The used hardware .

 

While designing the electronic circuit , we ran into a lot of problems . Luckily for us , we were able to solve all those problems , although it took quite a while sometimes . In what follows , an overview is given of the most important progresses that were made during our project .

 

Following subdivision can be made :

              

·        The used microcontroller

·        Reparation and calibration of the torque sensor

·        Calibration of the RPM sensor and conversion into a block wave

·        Frequency analysis of the analog output signal from the torque sensor

·        Used chips

·        Designed printboard

·        Display

·        Designed box for display